Pic 1: Results of test run.
Pic 2: Nuts embedded in the body.
Pic 3: IM part before cutting out the runner.
Pic 4: Javier in the shop =)
Also, here is an updated Gantt Chart of the Body IM team.
Thursday, April 3, 2014
Body IM Test Run and Updated Gantt Chart
The Body IM team (Javier & Xiaoyue) did a test run of the body injection molding. The body turned out well (see pictures below). The shims and nuts were successfully embedded in the plastic, and there were few flashes. We will do the optimization of injection setup next week.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment